One way to remove threaded rivets without a rivet gun is to use a drill with a drill bit slightly larger than the rivet's diameter. Carefully drill into the center of the rivet until the head pops off. Then, use a punch and hammer to drive the remaining rivet out of the hole. Another method is to use a grinder to grind off the head of the rivet, then use a punch and hammer to remove the remaining rivet. It's important to use caution and wear protective gear when using power tools. **

To attach rivet studs to rivet decorations, you will need a rivet setter tool and a hammer. First, place the rivet stud through the hole in the decoration. Then, place the rivet setter tool on top of the rivet stud and strike it with a hammer to secure the stud in place. Repeat this process for each rivet stud on the decoration until they are all attached securely. **

Yes, it is possible to rivet a motorcycle chain's rivet lock too tightly. If the rivet is compressed too much, it can cause the chain to bind and not move freely, leading to increased wear and potential damage to the chain and sprockets. It is important to follow the manufacturer's guidelines for riveting the chain and to ensure that the rivet is properly installed without being overly tightened. **

To remove a rivet, you will need to drill it out. Start by using a drill bit that is slightly smaller than the diameter of the rivet shaft. Place the drill bit in the center of the rivet head and slowly drill through the head until it pops off. Then, use a larger drill bit to drill out the remaining rivet shaft. Be careful not to drill too deeply and damage the surrounding material. Once the rivet is removed, you can replace it with a new one if needed. **

To rivet a bicycle chain, you will need a chain rivet tool. Start by aligning the chain rivet tool with the pin you want to remove. Turn the handle of the tool to push the pin out of the chain. Once the pin is removed, you can then align the ends of the chain you want to connect and use the chain rivet tool to push a new pin into place, securing the chain links together. Be sure to follow the manufacturer's instructions for your specific chain type to ensure proper installation. **

To calculate the rivet diameter, you need to consider the thickness of the materials being joined and the type of joint being created. The general rule of thumb is to use a rivet diameter that is 1.5 times the thickness of the materials being joined. However, for specific applications, it is important to consult engineering standards and guidelines to determine the appropriate rivet diameter. Additionally, factors such as the strength and load requirements of the joint should also be taken into consideration when calculating the rivet diameter. **

To rivet a bicycle chain, you will need a chain rivet tool. First, align the chain link you want to rivet with the tool's pin. Then, turn the handle of the tool to push the pin through the link until it is flush on both sides. Make sure not to push the pin all the way out. Finally, remove the chain from the tool and check that the link is securely riveted. **

To attach rivet-style studs, you will need a few tools such as a hole punch, a setting tool, and the studs themselves. First, use the hole punch to create a hole in the material where you want to place the stud. Then, insert the stud through the hole from the front side of the material. Place the setting tool over the back of the stud and hammer it down to secure the stud in place. Repeat this process for each stud you want to attach. Make sure to follow the specific instructions that come with your studs for the best results. **